Network Working Group H. Alvestrand Request for Comments: 2160 UNINETT Category: Standards Track January 1998
Carrying PostScript in X.400 and MIME
Status of this Memo
This document specifies an Internet standards track protocol for the Internet community, and requests discussion and suggestions for improvements. Please refer to the current edition of the "Internet Official Protocol Standards" (STD 1) for the standardization state and status of this protocol. Distribution of this memo is unlimited.
Copyright Notice
Copyright (C) The Internet Society (1998). All Rights Reserved.
Table of Contents
1 Introduction ............................................ 1 2 The PostScript body part ................................ 1 3 The PostScript FTBP ..................................... 2 4 The Application/PostScript content-type ................. 2 5 MIXER conversion ........................................ 2 6 MIXER conversion ........................................ 2 7 OID Assignments ......................................... 3 8 Security Issues ......................................... 3 9 Trademark Issues ........................................ 3 10 References ............................................. 3 11 Author's Address ....................................... 4 12 Full Copyright Statement ............................... 5
This document describes methods for carrying PostScript information in the two standard mail systems MIME and X.400, and the conversion between them. It uses the notational conventions of [BODYMAP], and the conversion is further described in [MIXER].
Two ways of carrying PostScript in X.400 are described. One is using the FTAM Body Part, and one uses the Extended Body Part originally described in RFC 1494.
The FTAM method is recommended.
Alvestrand Standards Track [Page 1]
RFC 2160 Carrying PostScript in X.400 and MIME January 1998
Carrying PostScript in X.400 as an Extended Body Part was originally defined in RFC 1494. This specification carries that work forward now that RFC 1494 is obsoleted by [BODYMAP].
The following Extended Body Part is defined for PostScript data streams. It has no parameters.
postscript-body-part EXTENDED-BODY-PART-TYPE DATA OCTET STRING ::= mime-postscript-body
X.400 Body Part: Extended Body Part, OID mime-postscript-body MIME Content-Type: application/postscript Conversion Type: No conversion
The two representations of PostScript both contain a single stream of octets. This stream of octets can be copied with no problems between the representations. No other data needs to be converted.
X.400 Body Part: FTBP, OID mime-ftbp-postscript-body MIME Content- Type: application/postscript Conversion Type: No conversion
Alvestrand Standards Track [Page 2]
RFC 2160 Carrying PostScript in X.400 and MIME January 1998
The two representations of PostScript both contain a single stream of octets. This stream of octets can be copied with no problems between the representations. No other data needs to be converted.
Copyright (C) The Internet Society (1998). All Rights Reserved.
This document and translations of it may be copied and furnished to others, and derivative works that comment on or otherwise explain it or assist in its implementation may be prepared, copied, published and distributed, in whole or in part, without restriction of any kind, provided that the above copyright notice and this paragraph are included on all such copies and derivative works. However, this document itself may not be modified in any way, such as by removing the copyright notice or references to the Internet Society or other Internet organizations, except as needed for the purpose of developing Internet standards in which case the procedures for copyrights defined in the Internet Standards process must be followed, or as required to translate it into languages other than English.
The limited permissions granted above are perpetual and will not be revoked by the Internet Society or its successors or assigns.
This document and the information contained herein is provided on an "AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.