Network Working Group K. Fujisawa Request for Comments: 2855 Sony Corporation Category: Standards Track June 2000
DHCP for IEEE 1394
Status of this Memo
This document specifies an Internet standards track protocol for the Internet community, and requests discussion and suggestions for improvements. Please refer to the current edition of the "Internet Official Protocol Standards" (STD 1) for the standardization state and status of this protocol. Distribution of this memo is unlimited.
Copyright Notice
Copyright (C) The Internet Society (2000). All Rights Reserved.
Abstract
IEEE Std 1394-1995 is a standard for a High Performance Serial Bus. Since 1394 uses a different link-layer addressing method than conventional IEEE802/Ethernet, the usage of some fields must be clarified to achieve interoperability. This memo describes the 1394 specific usage of some fields of DHCP messages.
IEEE Std 1394-1995 is a standard for a High Performance Serial Bus. IETF IP1394 Working Group specified the method to carry IPv4 datagrams and 1394 ARP packets over an IEEE1394 network [RFC2734].
The Dynamic Host Configuration Protocol (DHCP) [RFC2131] provides a framework for passing configuration information to hosts on a TCP/IP network.
Since 1394 uses a different link-layer addressing method than conventional IEEE802/Ethernet, the usage of some fields must be clarified to achieve interoperability. This memo describes the 1394 specific usage of some fields of DHCP. See [RFC2131] for the mechanism of DHCP and the explanations of each field.
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in RFC 2119 [RFC2119].
With conventional link-layer protocols, such as an Ethernet, the 'chaddr' (client hardware address) field may be used to return a reply message from a DHCP server (or relay-agent) to a client. Since a 1394 link address (node_ID) is transient and will not be consistent across the 1394 bridge, we have chosen not to put it in the 'chaddr' field. A DHCP client should request that the server sends a broadcast reply by setting the BROADCAST flag when 1394 ARP is not possible yet.
Note: In general, the use of a broadcast reply is discouraged, but we consider the impact in a 1394 network as a non issue.
Following rules should be used when a DHCP client is connected to an IEEE1394 network.
'htype' (hardware address type) MUST be 24 [ARPPARAM].
'hlen' (hardware address length) MUST be 0.
The 'chaddr' (client hardware address) field is reserved. The sender MUST set this field to zero, and the recipient and the relay agent MUST ignore its value on receipt.
A DHCP client on 1394 SHOULD set a BROADCAST flag in DHCPDISCOVER and DHCPREQUEST messages (and set 'ciaddr' to zero) to ensure that the server (or the relay agent) broadcasts its reply to the client.
Note: As described in [RFC2131], 'ciaddr' MUST be filled in with client's IP address during BOUND, RENEWING or REBINDING state, therefore, the BROADCAST flag MUST NOT be set. In these cases, the DHCP server unicasts DHCPACK message to the address in 'ciaddr'. The link address will be resolved by 1394 ARP.
'client identifier' option MUST be used in DHCP messages from the client to the server due to the lack of the 'chaddr'. 'client identifier' option may consist of any data. Because every IP over 1394 node has an EUI-64 (node unique ID), the EUI-64 makes an obvious 'client identifier'. 1394 clients SHOULD include an EUI-64 identifier in the 'client identifier' option. The type value for the EUI-64 is 27 [ARPPARAM], and the format is illustrated as follows.
Fujisawa Standards Track [Page 2]
RFC 2855 DHCP for IEEE 1394 June 2000
Code Len Type Client-Identifier +-----+-----+-----+-----+-----+-----+-----+-----+-----+-----+-----+ | 61 | 9 | 27 | EUI-64 (node unique ID) | +-----+-----+-----+-----+-----+-----+-----+-----+-----+-----+-----+
Note that the use of other 'client identifier' type, such as a fully qualified domain name (FQDN), is not precluded by this memo.
For more details, see "9.14. Client-identifier" in [RFC2132].
DHCP currently provides no authentication or security mechanisms. Potential exposures to attack are discussed in section 7 of the DHCP protocol specification [RFC2131].
A malicious client can falsify its EUI-64 identifier, thus masquerading as another client.
Acknowledgments
The author appreciates the members of the Dynamic Host Configuration Working Group for their review and valuable comments.
References
[RFC2734] Johansson, P., "IPv4 over IEEE 1394", RFC 2734, December 1999.
[RFC2119] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", RFC 2119, March 1997.
[RFC2131] Droms, R., "Dynamic Host Configuration Protocol", RFC 2131, March 1997.
[RFC2132] Alexander, S. and R. Droms, "DHCP Options and BOOTP Vendor Extensions", RFC 2132, March 1997.
Copyright (C) The Internet Society (2000). All Rights Reserved.
This document and translations of it may be copied and furnished to others, and derivative works that comment on or otherwise explain it or assist in its implementation may be prepared, copied, published and distributed, in whole or in part, without restriction of any kind, provided that the above copyright notice and this paragraph are included on all such copies and derivative works. However, this document itself may not be modified in any way, such as by removing the copyright notice or references to the Internet Society or other Internet organizations, except as needed for the purpose of developing Internet standards in which case the procedures for copyrights defined in the Internet Standards process must be followed, or as required to translate it into languages other than English.
The limited permissions granted above are perpetual and will not be revoked by the Internet Society or its successors or assigns.
This document and the information contained herein is provided on an "AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Acknowledgement
Funding for the RFC Editor function is currently provided by the Internet Society.